About the safe operation procedure of hot stamping machine
1. The hot stamping unit manager is responsible for supervising the safety of the hot stamping machine crew.
2. Before the operation of the bronzing machine, the workers must wear the overalls and work shoes neatly, fasten the placket and cuffs, do not install the clothes in the pockets, and do not wear watches and accessories. The clothes pockets are strictly prohibited from putting tools and coins. Items such as pens, mobile phones, lighters, etc., are not allowed to hang the keys around the waist to prevent them from falling into the machine.
3. Before the hot stamping machine is turned on, add the required lubricating oil (grease) to each oil filling point, lubrication point and fuel tank of the hot stamping machine.
4. Without approval, the non-hot stamping machine crew shall not start the bronzing machine without authorization, operate the bronzing machine, and the assistants and apprentices shall work under the guidance of the captain of the bronzing machine.
5. Before the machine of the hot stamping machine starts, whether there are any debris in the parts of the fuselage, the signal must be given first, and the back and forth should be echoed to ensure that the hot stamping machine can be safely opened before the machine can be opened.
6. Before the hot stamping machine is running, make sure that the unrelated personnel are close to the hot stamping machine.
7. The bronzing machine must check for foreign objects before and after the upper and lower plates to ensure that the plate-making screws are tightened. The action of the push plate should be light, so as not to damage the bronzing machine. During the operation of the bronzing machine, it is strictly forbidden to touch the moving working surface by hand. It is not allowed to repair and wipe the machine. It is not allowed to cross the rotating part, and the machine protection device of the bronzing machine should be kept complete.
8. The crew should strictly observe the position according to the division of labor, always pay attention to the operation of all parts of the hot stamping machine, and immediately stop the problem when the problem is found. Always turn off the main power switch when stopping for a long time.
9. The work site should be kept clean and tidy, ground. There is no debris around the workbench and bronzing machine, and the maintenance tools and spare parts should be placed in the specified position.
10. Pay attention to the hot stamping machine: When hot stamping to one (last) sheet, the machine pauses the alarm and starts to manually increase (decrease) the pressure. After adding (subtracting) the pressure, it will continue to run. When suspended, the operator pays attention to safety.
11. At work, no one is allowed to laugh, scream, and scream around the hot stamping machine.
12. At the end of the work, turn off the power of the hot stamping machine, and make sure that the waste paper is cleaned around the hot stamping machine, and no debris is on the machine.
13. The bronzing machine should regularly maintain and repair the machine.